Nilfisk-Advance SC500 User Manual

ENGLISH INSTRUCTIONS FOR USE
18 SC500 - 9099974000
11/2014
revised 07/2017
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be dened by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualied personnel, or by an authorised Service
Center.
CAUTION!
When the Service icon appears on the display (50), contact an authorised Nilsk Service Centre for
scheduled maintenance.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Battery Charging
Squeegee Cleaning
Brush/pad cleaning
Recovery tank and debris tray cleaning, and cover gasket check
EcoFlex system cleaning and draining
Squeegee Blade Check and Replacement
Solution Filter Cleaning
Battery (WET) uid level check
Squeegee blade replacement
Drive and brush motor vent check and cleaning (1)
Brush motor carbon brush check or replacement (1)
Drive system motor carbon brush check or replacement (1)
Brush deck vibration-damper replacement (only for REV version) (1)
(1) This maintenance procedure must be performed by an authorised Nilsk Service Center.

Nilfisk-Advance SC500 Specifications

General

Brand	Nilfisk-Advance
Model	SC500
Category	Floor Machine
Language	English