Nilfisk-Advance SC500 User Manual

ENGLISH INSTRUCTIONS FOR USE
2 SC500 - 9099974000
11/2014
revised 07/2017
INTRODUCTION
NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualied technicians must read this Manual carefully. Contact
Nilsk in case of doubts concerning the interpretation of the instructions and for any further information.
TARGET
This Manual is intended for operators and technicians qualied to perform the machine maintenance.
The operators must not perform procedures reserved for qualied technicians. Nilsk will not be answerable for damages coming
from the non-observance of this prohibition.
HOW TO KEEP THIS MANUAL
The Instructions for Use Manual must be kept near the machine, inside an adequate case, away from liquids and other substances
that can cause damage to it.
DECLARATION OF CONFORMITY
The Declaration of Conformity, supplied with the machine, certies the machine conformity with the law in force.
NOTE
Two copies of the original declaration of conformity are provided together with the machine documentation.
IDENTIFICATION DATA
The machine serial number and model name are marked on the plate (4).
Year of production (Date code: A17 means January 2017) and model number are marked on the same plate.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identication data.
Model .................................................................................................
Model number ....................................................................................
Serial number ....................................................................................
OTHER REFERENCE MANUALS
– Electronic battery charger Manual, to be considered as integral part of this Manual
– Spare Parts List (supplied with the machine)
– Service Manual (that can be consulted at Nilsk Service Centers)
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair procedures must be performed by qualied personnel or by Nilsk Service
Centers. Only original spare parts and accessories must be used.
Contact Nilsk for service or to order spare parts and accessories, specifying the model name, model number and serial number.
CHANGES AND IMPROVEMENTS
Nilsk constantly improves its products and reserves the right to make changes and improvements at its discretion without being
obliged to apply such benets to the machines that were previously sold.
Any change and/or addition of accessory must be approved and performed by Nilsk.

Nilfisk-Advance SC500 Specifications

General

Brand	Nilfisk-Advance
Model	SC500
Category	Floor Machine
Language	English