Nilfisk-Advance SC500 - Filter and Tracking Adjustment

ENGLISH INSTRUCTIONS FOR USE
24 SC500 - 9099974000
11/2014
revised 07/2017
SOLUTION FILTER CLEANING
1. Drive the machine on a level oor.
2. Ensure that the machine is off and the user key (51) has been removed.
3. Close the detergent solution tank valve (A, Fig. 14). The valve is closed when it is in position (B) and it is open when it is in
position (C).
4. Remove the transparent cover (D) and the gasket (E), then remove the lter strainer (F). Wash and rinse them, then ret them
carefully onto the lter support (G).
5. Open the valve (A).
G
E
F
D
AC
B
Figure 14
P100852
MACHINE TRACKING ADJUSTMENT
The machine tracking (straight movement) may vary according to the type of oor to be cleaned and depending on whether the
brush or the pad is used.
If it is difcult to keep the machine moving straight as it tends to pull to the left or to the right with the brush deck lowered and during
cleaning, adjust the handwheel (35) by turning it clockwise or counter-clockwise to correct this pull and obtain a generally neutral
straight-ahead movement.