EasyManuals Logo
Home>Nokia>Touch terminals>DNT2Mi sp/mp

Nokia DNT2Mi sp/mp User Manual

Nokia DNT2Mi sp/mp
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Data Network Terminal Single-port and Multiport Operating Instructions
16 (128) © Nokia Corporation DN01145897
Nokia Proprietary and Confidential Issue2-0en
4.1.1 Indicators and keys
Figure 4. Indicators and keys of the two DNT2Mi units
4.1.2 Local management interface
The local management interface is located behind the front panel door (see Figure
5). The interface is used to manage DNT2Mi with Macro Service Terminal
Emulator (MSTE) running on a PC or with other Nokia management software.
If signal 108 (DTR) is on, connecting the Service Terminal Emulator will
disconnect DNT2Mi from the remote network management. If signal 108 is off,
the entire network can be managed through this equipment.
Management interface cables of DNT2Mi are listed in Table 1.
Electrically, management interface signals comply with ITU-T V.28 or V.11. The
selection is made using either front panel menus or Q1 menus.
OK EXIT
DTR DSR DCD RTS CTS
STATUS
PWR TEST
P1
P2
P3
1. LED
indicators
2. LCD
display
3. Front
panel keys
Multiport DNT2Mi
Single-port DNT2Mi
OK EXIT
DTR DSR DCD RTS CTS
STATUS
PWR TEST
PORT
DNT2Mi
DNT2Mi

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nokia DNT2Mi sp/mp and is the answer not in the manual?

Nokia DNT2Mi sp/mp Specifications

General IconGeneral
BrandNokia
ModelDNT2Mi sp/mp
CategoryTouch terminals
LanguageEnglish

Related product manuals