Insert the memory card
A memory card may already be in the device. If not, do
the following:
1. Remove the back cover of the device.
2. Insert a compatible
memory card in the slot.
Ensure that the contact
area on the card is facing
down and towards the
slot.
3. Push the card in. You can
hear a click when the card
locks into place.
4. Replace the back cover. Keep
the device facing down when
replacing the cover. Ensure
that the cover is properly
closed.
Remove the memory card
Important: Do not remove the memory card in
the middle of an operation when the card is being
accessed. Removing the card in the middle of an
operation may damage the memory card as well as the
device, and data stored on the card may be corrupted.
1. Before you remove the card, press the power key,
and select Remove memory card. All applications
are closed.
2. When Removing memory card will close all open
applications. Remove anyway? is displayed,
select Yes.
3. When Remove memory card and press 'OK' is
displayed, remove the back cover of the device.
4. Press the memory card to release it from the slot.
5. Pull out the memory card. If the device is switched
on, select OK.
6. Replace the back cover. Ensure that the cover is
properly closed.
Antenna locations
Your device may have internal and external antennas.
As with any radio transmitting device, avoid touching
the antenna area unnecessarily while the antenna is
transmitting or receiving. Contact with such an
antenna affects the communication quality and may
cause the device to operate at a higher power level
than otherwise needed and may reduce the battery
life.
22
Get started
To Next Page
Loading...
Need help?
General
Weight and Dimensions
