66 NFS-320/E/C, NFS-320SYS/E Operations Manual — P/N 52747:E1 06/16/2011
Remote Terminal Access Using the CRT-2 for Alter Status
EXAMPLE Disable Detector address 101 on SLC1:
Press D to Disable (E to Enable); then press ENTER.
C.4.4 Change Alarm and Pre-Alarm Levels
This option lets you change the Alarm and Pre-alarm levels of any addressable detector in the
system. Follow these steps.
1. From the “Alter Status” menu select option 2 - Alarm/Pre-alarm.
2. Enter the address of the detector you wish to change. For example, change alarm and pre-alarm
levels for detector 102 on SLC 1 to Alarm Level 4 & Pre-alarm Level 2.
C.4.5 Clear Verification Counter
Clear verification lets you clear the verification counter for all the addressable detectors in the
system.
C.4.6 Clear the Entire History Buffer
Clear History lets you clear the entire History buffer.
D101 Now Enabled, Enter E(Enable) / D(Disable) or Esc. to Abort
Press <D><1><0><1><
ENTER>
Device now disabled
TROUBL SMOKE(PHOTO) DETECTOR ADDR 101 Z03 DEVICE DISABLED 08:29A Tue 01/15/08 D101
Press <D><
ENTER>
Det. Alarm/Prealarm level, type address D(
TROUBL SMOKE(PHOTO) DETECTOR ADDR 101 Z03 DEVICE DISABLED 08:29A Tue 01/15/08 D101
Press <2><
ENTER>
STATUS CHANGE Alarm/Prealarm level 08:29A Tue 01/15/08
D102 sens. at level 5, Prealarm at level 3, Enter AxPx to change, Esc. to Abort
D102 now set at new Alarm level 5 and new Pre-alarm level 2
Press <D><1><0><2><
ENTER><A><5><P><2><ENTER>
STATUS CHANGE Clear verify count 08:29A Tue 01/15/08
Press <3><
ENTER>
***************History Clear*************************
Press <4><
ENTER>
To Next Page
Loading...
Need help?
General
