1.
2.
•
Prerequisites
To separate the rails:
Extend the rail assembly by pulling the extension outwards (D).
Extract rail A from rail C by pushing it outside from the rear part of the assembly. To allow
complete separation of rail A from rail C, press the quick-release latch.
Rails Separation
Before mounting the system to the rack, select the way you wish to place the system. Pay attention
to the airflow within the rack cooling, connector and cabling options.
While planning how to place the system, review the following points:
Make sure the system air flow is compatible with your installation selection. It is important to
keep the airflow within the rack in the same direction.
The rails must be separated prior to the installation procedure.
To Next Page
Loading...
Need help?
General
