1.
2.
1.
2.
Grasping the handle with your right hand, push the latch release (if exists) with your thumb,
while pulling the handle outward. As the fan unit unseats, the fan unit status LEDs will turn
off.
Remove the fan unit.
To insert a fan unit:
Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue
pressing the fan unit until it seats completely.
Fan Module Latches Examples
The green Fan Status LED should light. If not, extract the fan unit and reinsert it. After two
unsuccessful attempts to install the fan unit, power off the system before attempting any
system debug.
To Next Page
Loading...
Need help?
General
