76 4 Settings on the Control Panel
Secure Print
Specifies whether to use the secure print feature.
[Enable] (default)
Select this to use the secure print feature.
[Disable]
Select this to prohibit secure print.
Note
• This item is displayed when the hard disk (optional) is installed.
Machine Clock
*3 (refer to P. 83)
Specifies the date (day/month/year) (for year, enter a number between 2000 and 2099) and
time (hour/minute) (for hours, enter a number in 24-hour format) of the printer system clock.
The date/time specified here will be printed on reports and lists.
nDate
Enter the date in the format of “dd/mm/yyyy” (e.g. 01/01/ 2002).
nTime
Enter the time in the format of “hh/mm” (e.g. 12/02).
nDate Format
Select the date display order from “yyyy/mm/dd” (year/month/day), “mm/dd/yyyy” (month/
day/year), and “dd/mm/yyyy” (day/month/year).
nTime Format
Select the time display from 12-hour display and 24-hour display.
nTime Zone
Specify the time zone if required.
nDaylight Savings, Start Date, End Date
Specify summer time if required.
Drum/Toner Life
When it is about time to replace the drum/toner cartridge, a message will appear on the
display. After the message is displayed, you can continue to print normally for about 100
sheets.
Specify whether to stop printing when the drum/toner cartridge needs to be replaced.
[Cancel Print] (default)
Select this to stop printing after the message notifying that it is about time to replace the
drum/toner cartridge was displayed and until it is replaced with a new one.
[Continue Print]
Select this not to stop printing even when the drum/toner cartridge needs replacing. Note
that continuous printing after the replacement time has passed may affect the print image
quality and the printer performance. It is recommended to install a new drum/toner
cartridge.
mm/inch
Specifies the unit that is used on the control panel from [Millimeter (mm)] and [Inch (“)].
This default setting varies depending on the countries.
To Next Page
Loading...
Need help?
General
