To Next Page

To Previous Page

80 4 Settings on the Control Panel

Buffer Size

For each interface, specify the memory capacity of the receive buffer (in which the data sent

from a computer is saved temporarily). For LPD, SMB, and IPP, specify the availability of

spool processing, locations, and memory capacity.

You can change the receive buffer capacity depending on how busy the conditions are and

purposes. Increasing the receive buffer capacity may increase the disconnection speed of

the computer for each interface. The maximum capacity you can set varies depending on

the free memory capacity.

Note

• If a port is disabled, the items for it will not be displayed.

• Even if the memory capacity is increased, the disconnection speed of a computer may not be changed

due to the data volume sent from a computer.

nParallel, Serial, NetWare Memory, IPP Memory, USB Memory, Port9100 Memory

Specify the memory capacity between 64 and 1024 KB in increments of 32 KB. The default

is [64 K] for parallel and USB memories and [256 K] for the other memories.

Note

• [IPP Memory] is displayed when the hard disk (optional) is not installed. [IPP Spool] is displayed when

the hard disk is installed.

nEtherTalk Memory

Specify the memory capacity between 1024 and 2048 KB (64 and 1024 KB when the

mounted RAM is under 256 MB) in increments of 32 KB. The default is [1,024K].

nLPD Spool, SMB Spool

[Off] (default)

Select this if you do not want to perform spool processing. When the LPD or SMB data from

a computer is being processed, data from another computer cannot be received via the

same interface.

For LPD, specify the LPD specific receive buffer memory capacity between 1024 and 2048

KB (64 and 1024 KB when the mounted RAM is under 256 MB) in increments of 32 KB. The

default is [1,024K].

For SMB, specify the SMB specific receive buffer memory capacity between 64 and 1024

KB in increments of 32 KB. The default is [256K].

[Hard Disk]

Select this to perform spool processing. This uses the hard disk as the receive buffer for

spool processing. This item is displayed when the hard disk (optional) is installed.

Oki B6200dn Reference Guide

Other manuals for Oki B6200dn