Menu functions > 33
A
DMIN
SETUP
ITEM SETTINGS EXPLANATION
Enter
Password
xxxxxxxxxxxx Enter a password to gain entry to the Admin
Setup menu.
Password should be from 6 to 12 digits of
alpha/numeric characters (or mix)
The default value is ā999999ā
Network
Setup
Enabling Default
Gateway
Wired
Wireless
(Infrastructure)
Sets a valid default gateway.
Display Conditions:
There should be built-in wireless LAN support
and Boot Menu > Wireless Module should
be enabled.
Wired Enable
Disable
Enables/Disables the wired LAN.
TCP/IP Enable
Disable
Sets TCP/IP Protocol.
Enable: TCP/IP Protocol is available.
Disable: TCP/IP Protocol is not available.
NetBIOS over TCP Enable
Disable
Sets Enable/Disable of NetBIOS over TCP
protocol.
Display Conditions: TCP/IP should be enabled.
IP Address Set Auto
Manual
Sets the IP Address setting method.
Display Conditions: TCP/IP should be enabled.
IPv4 Address xxx.xxx.xxx.xxx Sets the IP Address.
Display Conditions: TCP/IP should be enabled.
Subnet Mask xxx.xxx.xxx.xxx Sets the Subnet Mask.
Display Conditions: TCP/IP should be enabled.
Gateway Address xxx.xxx.xxx.xxx Sets the Gateway (default router) address.
0.0.0.0 means that there is no router.
Display Conditions: TCP/IP should be enabled.
DHCPv6 Enable
Disable
Sets Enable/Disable of DHCPv6.
Web Enable
Disable
Sets Enable/Disable of Web.
Enable: Web/IPP is available.
Disable: Web/IPP is not available.
Display Conditions: TCP/IP should be enabled.
Teln et En abl e
Disable
Sets Enable/Disable of Telnet.
Enable: Telnet is available.
Disable: Telnet is not available.
Display Conditions: TCP/IP should be enabled.
FTP Enable
Disable
Sets Enable/Disable of FTP.
Enable: FTP is available.
Disable: FTP is not available.
Display Conditions: TCP/IP should be enabled.
IPSec (if enabled) Enable
Disable
Sets Enable/Disable of IPSec. Enable via the web.
Enable: IPSec is available.
Disable: IPSec is not available.
SNMP Enable
Disable
Sets Enable/Disable of SNMP.
Enable: SNMP is available.
Disable: SNMP is not available.
Display Conditions: TCP/IP or NetWare
should be enabled.