Configuring your machine... > 33
N
ETWORK
SET
UP
The MFP must also be set up properly on your network to perform scan to e-mail and other
functions. In order for other network devices to find the MFP on the network, the following
network parameters have to be set.
1. IP Address Set:
2. IP Address:. . .
3. Subnet Mask:. . .
4. Gateway Address:. . .
5. DNS Server:. . .
6. SMTP Server:. . .
7. SMTP Port:25
8. POP3 Server:. . .
9. POP3 Port:110
Explanation:
1. IP Address Set:
Choose Auto to obtain IP/subnet/gateway addresses automatically from DHCP server.
After changing setting from Manual to Auto, the MFP will automatically reboot the
network card.
2. IP Address:
The Internet Protocol (IP) address assigned to your machine by your network
administrator.
3. Subnet Mask:
The net mask address assigned by your network administrator.
4. Gateway Address:
The gateway IP address assigned by your network administrator.
5. SMTP Server:
The IP address of your SMTP Mail Server assigned by your network administrator.
6. SMTP Port:
The port number of your SMTP Mail Server.
7. DNS Server:
The IP address of DNS Server assigned by your network administrator.
8. POP3 Server:
The IP address of your POP3 server.
9. POP3 Port:
The port number of your POP3 Server.
Enter the DNS name, or IP and port number of your POP3 server if your mail server
requires POP3 authentication, before sending e-mails from the machine.
NOTE
You must also set up the “From” details to allow e-mail sending.
To Next Page
Loading...
Need help?
General
