USING YOUR PRINTER > 16
SETTING TOP OF FORM (TOF)
The first line prints at the red line (1) of the plastic paper shield on the
printhead.
Forms Tear-Off set to OFF - default
With paper loaded and the printer ON and selected:
1.
Press
PARK
(6) to park the paper.
The SEL light goes off and the red alarm light comes on.
2.
Press
FF | LOAD
(4) to load the paper.
3.
If the printer is ON line, press
SEL
|
MENU
(1) to take the
printer
OFF
line.
The SEL light goes out.
4.
Press and hold
SHIFT
(2), then:
l Press
LF | Micro Feed Down
(3) to set the TOF higher (the
paper moves down).
l Press
FF/LOAD | Micro Feed Up
(4) to set the TOF lower
(the paper moves up).
(When you begin pressing the Micro Feed key, the printhead will move
to the right).
5.
Press
SEL | MENU
(1) to place the printer back on line.
To reset the Top of Form to the factory default, see “Resetting Top of
Form to the Factory Default” later in this chapter.
CAUTION!
If you turn the platen knob when the printer is not at Top of Form, the
TOF will misalign. Always feed the paper to TOF before turning the
platen knob!
1
2
3
4
6
75
To Next Page
Loading...
Need help?
General
