USING YOUR PRINTER > 24
PRINTHEAD GAP
1.
The printhead gap is the distance between the printhead and
the platen.
To adjust the gap, open the access cover and move the coloured lever
(1) to the recommended setting from the table.
CAUTION!
Make sure the printer is turned OFF before you open the access cover.
Setting Media
1Standard paper
2 2-part form (with carbon)
33-part form (with carbon)
4 4-part form (with carbon)
5 Envelopes or extra thick paper
NOTE
When the head gap is set to 2, 3, 4 or 5, the printer automatically slows
down for better print quality with multipart forms.
1
To Next Page
Loading...
Need help?
General
