Olympus AFU-100 User Manual

Instructions for Use EN Olympus AFU-100
20 WB135745-W10
NOTE
If the peristaltic pump unit is connected via the communication cable
with an electrosurgical unit and communication is established, the
footswitch of the peristaltic pump unit cannot be used. In this case, the
peristaltic pump unit will be controlled by the electrosurgical unit’s
footswitch.
6.6 Connection to an electrosurgical unit
The peristaltic pump unit together with an electrosurgical unit can build a system as
shown in fig. 6.4. If the communication to an electrosurgical unit is established and both
units are switched on, a special button on the electrosurgical unit’s footswitch activates
the pump flow.
Align the plugs of the communication cable that the keying is facing down and insert the
plugs into the communication ports of the electrosurgical unit and the peristaltic pump
unit and rotate the fastener rings fully clockwise to tighten it (see fig. 6.4).
Fig. 6.4: Connection of an electrosurgical unit (e.g. ESG-100) and the peristaltic pump
unit
NOTE
It is recommended to position the electrosurgical unit on top of the
peristaltic pump unit to avoid spilling of liquids over the electrosurgical
unit.
7 Operation
Prepare this peristaltic pump unit and other equipment to be used with this unit for the
particular operation. Refer to the respective instructions for use for each item. Confirm
that the connections of the power cord, footswitch, pump tube and instruments are
secure and correct.

Olympus AFU-100 Specifications

General

Brand	Olympus
Model	AFU-100
Category	Water Pump
Language	English