Omron E5EC Communications Manual

6 - 3
6 Programless Communications
E5@C Digital Temperature Controllers Communications Manual (H175)
6-1 Programless Communications
6
6-1-1 Introduction
6-1 Programless Communications
With programless communications you can read and write E5@C parameters or start and stop the
E5@C from a Programmable Controller (PLC). Communications with the PLC are performed automati-
cally by the E5@C, so there is no need to program communications.
• You can connect to an OMRON CS/CJ-series or CP-series PLC, to a Mitsubishi Q-series, L-series,
or FX-series PLC, or to a Keyence KV-series PLC.
• Up to 13 E5@C parameters can be assigned for reading and up to 13 E5@C parameters can be
assigned for writing in PLC memory. Each E5@C Controller is allocated 30 words of PLC memory.
(Only 12 parameters can be read for Mitsubishi FX-series or Keyence KV-series PLCs.)
• You can set the PLC memory area and addresses to use for programless communications.
• You can copy settings between E5@C Controllers to greatly reduce setup work and setting mistakes.
6-1-1 Introduction
6-1-2 Features
25
0
C
25
0
C
25
0
C
E5CC
No.0
E5CC
No.1
E5CC
Up to 32 E5@C Controllers on one communications line (up to 16 Controllers for a Mitsubishi FX-series PLC)
No.2
25
0
C
25
0
C
E5CC
No.n
PLC
The E5@C automatically reads
and writes PLC memory.
25
0
C
25
0
C
25
0
C
E5CC
PLC memory
PV, status, etc.
No.0
E5CC
No.1
E5CC
No.2
No. 0
Upload Area
No. 0
Download Area
No. 1
Upload Area
No. 1
Download Area
No. 2
Upload Area
No. 2
Download Area
Set point, alarm value, etc.
You can change the PLC
memory area and addresses.
Up to 13 parameters can be set for reading and
up to 13 parameters can be set for writing.
Settings can
be copied.
Each E5@C Controller
is allocated 30 words.

Omron E5EC Specifications

General

Brand	Omron
Model	E5EC
Category	Temperature Controller
Language	English