6 Programless Communications
6 - 72
E5@C Digital Temperature Controllers Communications Manual (H175)
(5) We will write set values to the PLC.
When the following dialog box is displayed, click the Close Button to close it and cycle the
power to the PLC.
This completes the PLC setup procedure. You will use GX Works2 to check operation, so
leave it online.
Set up programless communications. Perform the procedure that is given in 6-4-4 E5
@
C Controller
Setup.
Perform the checking operation given in 6-8-5 Checking Operation.
6-9-4 E5@C Controller Setup
6-9-5 Checking Operation