EasyManuals Logo
Home>Omron>Temperature Controller>E5EC

Omron E5EC Communications Manual

Omron E5EC
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #127 background imageLoading...
Page #127 background image
6 - 13
6 Programless Communications
E5@C Digital Temperature Controllers Communications Manual (H175)
6-2 E5C Setup
6
6-2-8 Upload Settings and Download Settings
You can use the settings in the following table for the upload settings and download settings.
Note: 1 If nothing is assigned for an upload setting, the corresponding address in the upload area will contain 0. If
nothing is assigned for a download setting, nothing will be done in the download area.
2 If the same value is set for more than one download setting, only the download setting with the lower
number will be valid. The other download setting will be treated as if nothing was assigned. All upload set-
tings are valid even if the same value is set more than once.
Set value Set value
Upload settings (Cannot be used for download settings.)
0 Nothing assigned.
Upload or Download Settings
54 SP 5
1 Communications Monitor 55 SP 6
2 Status (Upper Word) 56 SP 7
3 Status (Lower Word) 57 Process Value Input Shift
4 Status 2 (Upper Word) 58 PV Input Slope Coefficient
5 Status 2 (Lower Word) 59 Remote SP Input Shift
6 Decimal Point Monitor 60 Remote SP Input Slope Coefficient
7 Process Value 61 Proportional Band
8 Internal Set Point 62 Integral Time
9 Multi-SP No. Monitor 63 Derivative Time
10 Remote SP Monitor 64 Proportional Band (Cooling)
11 Heater Current 1 Value Monitor 65 Integral Time (Cooling)
12 Heater Current 2 Value Monitor 66 Derivative Time (Cooling)
13 Leakage Current 1 Monitor 67 Dead Band
14 Leakage Current 2 Monitor 68 Manual Reset Value
15 Soak Time Remain 69 Hysteresis (Heating)
16 MV Monitor (Heating) 70 Hysteresis (Cooling)
17 MV Monitor (Cooling) 71 Soak Time
18 Valve Opening Monitor 72 Wait Band
19 Spare 73 MV at Stop
· · · · · · 74 MV at PV error
Upload or Download Settings
30 Nothing assigned. 75 SP Ramp Set Value
31 Set Point 76 SP Ramp Fall Value
32 Alarm Value 1 77 MV Upper Limit
33 Alarm Value Upper Limit 1 78 MV Lower Limit
34 Alarm Value Lower Limit 1 79 MV Change Rate Limit
35 Alarm Value 2 80 Extraction of Square Root Low-cut
Point
36 Alarm Value Upper Limit 2 81 Work Bit 1 ON Delay
37 Alarm Value Lower Limit 2 82 Work Bit 1 OFF Delay
38 Alarm Value 3 83 Work Bit 2 ON Delay
39 Alarm Value Upper Limit 3 84 Work Bit 2 OFF Delay
40 Alarm Value Lower Limit 3 85 Work Bit 3 ON Delay
41 Alarm Value 4 86 Work Bit 3 OFF Delay
42 Alarm Value Upper Limit 4 87 Work Bit 4 ON Delay
43 Alarm Value Lower Limit 4 88 Work Bit 4 OFF Delay
44 Manual MV 89 Work Bit 5 ON Delay
45 Heater Burnout Detection 1 90 Work Bit 5 OFF Delay
46 Heater Burnout Detection 2 91 Work Bit 6 ON Delay
47 HS Alarm 1 92 Work Bit 6 OFF Delay
48 HS Alarm 2 93 Work Bit 7 ON Delay
49 SP 0 94 Work Bit 7 OFF Delay
50 SP 1 95 Work Bit 8 ON Delay
51 SP 2 96 Work Bit 8 OFF Delay
52 SP 3 97 Position Proportional Dead Band
53 SP 4 98 Open/Close Hysteresis

Table of Contents

Other manuals for Omron E5EC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron E5EC and is the answer not in the manual?

Omron E5EC Specifications

General IconGeneral
BrandOmron
ModelE5EC
CategoryTemperature Controller
LanguageEnglish

Related product manuals