Omron E5EC Communications Manual

6 - 41
6 Programless Communications
E5@C Digital Temperature Controllers Communications Manual (H175)
6-6 Connecting to the NX1P2
6
6-6-3 PLC Setup
(2) On the Multiview Explorer, double-click Option Board Settings under Configuration
and Setup
− Controller Setup. The Option Board Settings Tab Page will be displayed.
Select NX1W-CIF11 from the Option board 1 Box under Configuration.
(3) Change the following serial communications setting of Option Board 1.
Change the baud rate to 57600 bps. Use the default values for other settings.
(4) Set up the memory for CJ-series Units.
The E5C uses the DM Area in the memory for CJ-series Units in the NX1P2 as the
upload and download areas.
On the Multiview Explorer, double-click Memory Settings under Configuration and Setup
− Controller Setup. The Memory Settings for CJ-series Units Tab Page will be displayed.
Select the enable check box for the DM Area.

Omron E5EC Specifications

General

Brand	Omron
Model	E5EC
Category	Temperature Controller
Language	English