Omron LD-90 User Manual

158 LD Cart Transporter User's Manual 14766-000 Rev H
10.7 Removing and Installing LD Platform Cart Transporter Covers
Installing Top Plate
1.
Resintall the top plate.
!
CAUTION: PROPERTYDAMAGERISK
Take care not to scratch the laser lens when reinstalling the top plate.
2.
Reconnect the cabling to the latching motor assembly and its sensors.
3.
Reinstall the eight M6 screws along the sides and front of the top plate.
Use the screws previously removed from the top plate.
4.
Reinstall the two M5 screws that were covered by the Latching Mechanism cover.
Use the screws previously removed from the top plate.
Installing Latching Mechanism Cover
1.
Place the Latching Mechanism cover back onto the top plate.
2.
Reinstall the four M3 screws holding the Latching Mechanism cover to the top plate.
Use the screws previously removed from the Latching Mechanism cover.
These go into four 45 mm standoffs in the top plate.
10.7 Removing and Installing LD Platform Cart Transporter Covers
Many of the maintenance procedures require removing some of the platform's covers. Most
covers are held in place with just magnets. The rear outer cover has an additional brace at the
bottom for support, the bumper cover uses screws and magnets, and the access panel uses just
a push-push (toggle) latch.
Figure 10-8. LD Platform OEM Skins

Omron LD-90 Specifications

General

Brand	Omron
Model	LD-90
Category	Robotics
Language	English