Omron NX102 series Network Connection Guide

7．IO-Link Connection Procedure
32
Checking Sent Data
Check that correct data is sent.
Ensure that CX-ConfiguratorFDT is installed on your personal computer, which is provided in
the Sysmac Studio package.
In this procedure, the output of the Signal Tower is performed, which may have a
risk of unexpected operation of the devices connected to the Signal Tower.
Ensure safety before you proceed with this operation check described here.
If you cannot ensure safety, do not proceed. When you perform this operation
check, make sure you complete all the steps and make the output of the Signal
Tower safe.
If you wire I/O in a state where the devices are powered ON, it may cause
damage to the devices.
Always read and follow the information provided in all safety precautions in the
manuals for each device before wiring.
If you change the variable values on a Watch Tab Page when Sysmac Studio is
online with the CPU Unit, the devices connected to the Controller may operate
regardless of the operating mode of the CPU Unit.
Always ensure safety before you change the variable values on a Watch Tab
Page when Sysmac Studio is online with the CPU Unit. .
1
Select Watch Tab Page from the
View Menu.
2
The Watch (Project)1 Tab Page is
displayed.

Omron NX102 series Specifications

General

Brand	Omron
Model	NX102 series
Category	Controller
Language	English