42
3–1 Operational Flow
The basic procedure used to operate the Unit initially is outlined below. Refer
to applicable sections of the manual for details on each of these steps.
Item
Wiring
Data setting
Start
Wiring motor to
driver
Setting back-pan-
el DIP switch
Data setting
Origin, origin proximity, CW/CCW
limits, emergency stop, external in-
terrupt
Output pulse selection
Origin search direction
Origin proximity signal type
Origin signal type
External interrupt signal type
DM area (key input via Program-
ming Console)
Parameters
Positioning actions
Speeds
Refer to
Wiring external
inputs
Follow motor and driver and instruction
manuals for wiring details
Wiring Position Control
Unit to driver
Section 2–2
Section 3–4
Section 2–1
Section 4
Section 3–7–4
Section 5
Writing PC
program
Programming IR area (key input via
Programming Console)
Procedure
Operational Flow Section 3–1
To Next Page
Loading...
Need help?
General
