Onkyo DR-UN7 User Manual

28
Customizing the Source Names
You can change the source name that appears in the display to suit any component you connected per the instruc-
tions on pages 21-23.
About short source names
The short source names appear in the display depending
on the situation. Check the short names in the table
below.
Note:
Pages 78 and 79 offer a list of the remote controller but-
tons you can use after you have changed the source
names.
1
Press INPUT / until the source
whose name you wish to change
appears in the display.
You can select TAPE, LINE or DIGI-
TAL.
2
Press EDIT/NO/CLEAR repeatedly
until “Name Select?” appears in
the display.
3
Press MULTI JOG.
4
Turn MULTI JOG to select a new
name for the source.
Depending on the source you’ve selected
in step 1, the name changes in the follow-
ing order:
“Complete” appears in the display.
1
2
3-5
Display
DIGITAL
GAME/dig
TV/dig CD-R/dig
LINE
GAME
TV
PC
*1
PC/dig
*1
TAPE HDD CD-R
*1 Select this if you connected an
Onkyo USB component that sup-
ports connection.
5
Press MULTI JOG to enter the new
name.
“Complete” appears in the display. You
may press YES/MODE instead of
MULTI JOG to get the same result.
Ordinary names Short names
CD-R CR
DIGITAL DG
GAME GM
HDD HD
LINE LI
PC PC
TAPE TA
TV TV

Onkyo DR-UN7 Specifications

Power

power supply	AC 120 V, 60 Hz
power consumption	115 W
stand-by power consumption	0.2 W

Operating Environment

operating temperature	5 ˚C–35 ˚C
operating humidity	5 %–85 %
tuning frequency range	87.5 MHz–107.9 MHz

Audio Specifications

signal to noise ratio	100 dB (LINE, IHF-A)
frequency response	10 Hz–100 kHz/±3 dB (LINE)
total harmonic distortion	5 % (Power Rated)

Weight and Dimensions

dimensions	205 W x 147 H x 353 D mm
weight	5.4 kg