55
Setting the Clock
Setting AccuClock Using a Specific Station
RDS is only available in areas where RDS broadcasts are available.
The AccuClock function normally uses the FM station with the strongest signal to set the clock. However, if the clock
cannot be set properly using that station, you can specify the FM station the which AccuClock function uses. This must
be an FM station that supports RDS CT (Clock Time) information.
1
Press the [TIMER] button.
“Clock” appears on the display.
If the clock has already been set, a timer
option appears instead, in which case you’ll
need to press the [TIMER] button
repeatedly until “Clock” appears.
2
Press [ ].
“AccuClock” appears on the display.
If “ManualAdjust” appears, use the
Previous and Next [ ]/[ ] buttons to
select “AccuClock” or “*AccuClock*”.
3
Press [ ].
The frequency flashes on the display.
4
Use the Fast Reverse and Fast
Forward [ ]/[ ] buttons to tune
into the FM station.
Tip:
The RDS indicator appears when tuned into
a station that supports RDS.
The RDS indicator will flash while the
stereo receiver searches for a station and
light up continuously when a station is
found.
5
When you’ve selected the station,
press [ ].
While the clock is being set, “Wait” flashes
on the display. It may take a few minutes to
set the clock. When the clock has been set,
the message “Clock Adjusted” scrolls
across the display, then the day and time are
displayed for a while.
• If the clock is not set correctly, specify
another FM station and try again or set
the clock manually (see page 56).
• The AccuClock function automatically
updates the clock every day. If you don’t
want it to, you can turn off the
AccuClock function (see page 23).
To Next Page
Loading...
Need help?
General
