Troubleshooting—Continued
65
iPod/iPhone
There's no sound.
• Make sure that the iPod is connected to the receiver properly.
• Make sure that no video content is being played.
• Reset the iPod.
Other
• Do not control Cover Flow during playback. Otherwise, the receiver may generate noise.
• During playback on the iPod nano or iPod (5th generation), "ONKYO" is displayed on the iPod display and the quick
wheel cannot work.
External Components
No sound is heard from a connected component.
• Make sure the correct input source is selected (see page 25).
• Make sure the analog audio cable is connected correctly (see page 21).
• Make sure that all audio connecting plugs are pushed in all the way (see page 16).
No sound is heard from your turntable.
• Make sure the turntable has a built-in phono equalizer.
• If the turntable doesn’t have a phono equalizer built-in, you must provide one.
• Make sure that the turntable has a built-in phono equalizer.
If it has a phono equalizer built-in, connect the turntable to LINE1, LINE2 or LINE3 of the stereo receiver.
Remote Controller
The remote controller doesn't work properly.
• Make sure the batteries have been installed with the correct polarity (+/-) (see page 8).
• Replace both batteries with new ones. (Do not mix different types of batteries or new and old batteries.)
• The remote controller is too far away from the stereo receiver, or there’s an obstacle between them (see page 8).
• The stereo receiver’s remote control sensor is being subjected to bright light (inverter-type fluorescent light or
sunlight).
• The stereo receiver is located behind the glass doors of a audio rack or cabinet.
• Make sure that the iPod is connected to the receiver properly.
• The remote controller does not work while the Apple logo is displayed on the iPod display.
• Insert and remove the iPod connector from the receiver.
• Reset the iPod.
does not work.
• There’s no analog audio connection. To use you must make an analog audio connection between the C-1045 and
your Onkyo component.