EasyManuals Logo

Onkyo TX-SR494 User Manual

Onkyo TX-SR494
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #82 background imageLoading...
Page #82 background image
82
Front Panel Rear Panel Remote
Contents
Connections
Playback
Setup
When the unit is operating erratically
Try restarting the unit
Restarting this unit may solve the problem. After turning the unit to standby mode, press and hold the ON/STANDBY button of the main unit for at least 5 seconds, and then restart
the unit. (The settings on this unit are kept.) If the problem persists after restarting the unit, unplug and plug the power cords or HDMI cable of this unit and connected devices.
Resetting the unit (this resets the unit settings to the default)
If the restart of the unit does not solve the problem, reset the unit, and restore all the settings to the factory default at the time of purchase. This may solve the problem.
If the unit is reset, your settings are restored to the default values. Be sure to note down your setting contents before performing the following operations.
1. While pressing and holding CBL/SAT of the input selector on the main unit with the unit turned on, press the ON/STANDBY button.
2. "Clear" is displayed on the display, and the unit returns to the standby state. Do not remove the power cord until "Clear" disappears from the display.
1
2

Table of Contents

Other manuals for Onkyo TX-SR494

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo TX-SR494 and is the answer not in the manual?

Onkyo TX-SR494 Specifications

General IconGeneral
Receiver typeSurround
Frequency range10 - 100000 Hz
Output impedance4 - 16 Ω
Input sensitivity200 mV
4Ω speaker supportYes
Audio output channels7.2 channels
Signal-to-Noise Ratio (SNR)109 dB
Total Harmonic Distortion (THD)0.08 %
Power output per channel (20-20KHz@8 Ohm)80 W
HDMI in4
Audio (L/R) in3
Digital audio optical in1
Component video (YPbPr/YCbCr) in0
Audio (L/R) out8
Connectivity technologyWired
Speakers connectivity typeBanana connector/Binding posts
Wi-FiNo
AM band range530 - 1710 kHz
FM band range87.5 - 107.9 MHz
Supported radio bandsAM, FM
Preset stations quantity40
AirPlay-
DisplayLCD
HDCP version2.2
Product colorBlack
Audio decodersDTS Virtual:X, Dolby Atmos
AC input voltage120 V
AC input frequency60 Hz
Power consumption (standby)0.1 W
Power consumption (typical)490 W
THX-certifiedTHX
Weight and Dimensions IconWeight and Dimensions
Depth328 mm
Width435 mm
Height160 mm
Weight10500 g

Related product manuals