32 33
SETTING UP YOUR ANNEX PROPANE HEATER
TO ATTACH THE WALL SKIRTS
With your OPUS® annex fully inated, you’re ready to assemble the annex, and the rst step is to aach the wall skirt:
STEP 1 - Posion the OPUS® wall skirt along the entry side wall of your OPUS® Camper.
STEP 2 - Aach the skirt with the Velcro strips and zips around the edges.
STEP 3 - Peg the skirt to the ground with the ve D-rings along the boom edge.
Attach the wall skirts
With your OPUS
®
Camper fully erected, you’re ready to assemble the annex,
and the first step is to attach the wall skirt:
STEP 1 - Position the OPUS
®
wall skirt along the entry side wall of your OPUS
®
Camper.
STEP 2 - Attach the skirt with the Velcro strips and zips around the edges.
STEP 3 - Peg the skirt to the ground with the five D-rings along the bottom edge.
INSTALLING YOUR AIR OPUS® ANNEX
Page 28
PROPANE HEATER
MODEL INFORMATION: DOMETIC SMALL FURNACE 16,000 BTU
Please read the Domec user manual for this appliance that is provided with your OP4 for full instrucons and maintenance.
Failure to follow the manufacturer’s instrucons can lead to damage, serious injury or death. Damage to the appliance
or the OPUS as a result of failure to follow the manufacturer’s guidelines for use and maintenance is not covered under
warranty. IMPORTANT! Ensure that nothing is stored inside the compartment that the propane furnace is installed in and
that nothing is blocking the vent on either the interior or the exterior of the camper.
TO TURN THE FURNACE ON:
STEP 1: Turn on power to the trailer (red key)
STEP 2: Turn on the heater switch on the control panel
STEP 3: Open your propane. 1 turn of the tap for a full tank should be
sucient
STEP 4: Set the thermostat to the desired heat. This is the slide on the
BOTTOM of the thermostat next to the heater outlet inside the camper. Slide
to the right for higher heat and le for lower heat
STEP 5: Turn the heater switch to “on”. This is the toggle switch on the top of
the thermostat. Click it to the LEFT to turn it on
STEP 6: You will hear the fan start up rst followed by the pilot clicking to
ignite.
TO TURN THE FURNACE OFF:
STEP 1: Turn the toggle on/o switch on the thermostat to the right “O”
posion
STEP 2: Turn the temperature all the way down to the le
STEP 3: Wait for the propane heater & fan to cycle o
STEP 4: When packing down the OPUS, turn the heater switch on the control
panel o and turn the red key o and remove.
TROUBLESHOOTING
If the heater does not kick-on then try turning the temperature up higher. The
thermostat needs to register a parcular temperature dierence in order to
turn on.
The pilot will click three mes and if it does not ignite it will wait 7-10 seconds
before re-trying. It will re-try this cycle three mes in total before moving to
error mode. You can use your Domec furnace user manual to idenfy the error
message but some quick troubleshoong ps are as follows:-
• Check you have enough propane in your propane cylinder
• Try turning the thermostat o completely – Turn the temperature all the
way to the le and the toggle on/o switch to the right. Wait for the air
cycle to complete and the fan to stop then wait 30 seconds before turn-
ing the heater on again. DO NOT use the switch on the control panel to
turn the furnace on & o as this can confuse the cool-down cycle of the
furnace.
• If it sll does not turn on, try re-seng the furnace. To do this, Turn the
temperature all the way to the le and the toggle on/o switch to the
right. Wait for the air cycle to complete and the fan to stop. Then re-set
the furnace by using the switch on the top of the furnace (pictured).
• Turn it o then on again to re-set the furnace then follow
the start-up quesons again.
• Check you are receiving propane to your kitchen stove to
idenfy whether there might be a regulator malfuncon.
To Next Page
Loading...
Need help?
General
