Upgrading Controller A (CLI)
Note - You need to create a pool if one does not already exist.
The pool should be online and have no errors.
Controller A is now upgraded.
Next Steps
■
Upgrading Controller B - BUI
Upgrading Controller A (CLI)
Use the following procedure to upgrade the first controller, controller A, of a clustered
appliance.
1.
Go to maintenance system reboot and enter y to reboot the appliance.
controller-a:> maintenance system reboot
This will reboot the appliance. Are you sure? (Y/N) y
2.
After the reboot completes, log back into the CLI and enter configuration cluster
show to verify that controller A is in the passive state.
In the example below, the state of controller A is AKCS_STRIPPED, which is the passive state.
controller-a:> configuration cluster show
state = AKCS_STRIPPED
...
peer_state = AKCS_OWNER
peer_description = Active
For information about the clustered states, see “Cluster Takeover and Failback” in Oracle ZFS
Storage Appliance Administration Guide, Release OS8.6.0.
3.
Go to maintenance system updates and enter show to view the available updates.
controller-a:> maintenance system updates
controller-a:maintenance system updates> show
Updates:
UPDATE DATE STATUS
ak-nas@2013.06.05.1.1,1-1.2 2013-12-6 23:37:50 previous
ak-nas@2013.06.05.2.0,1-1.9 2014-5-28 15:20:06 current
Upgrading the Software 331
To Next Page
Loading...
Need help?
General