ENGLISH
7
A weak or missing battery can cause the time, date, and program to be erased
after a power failure. If this happens, you will need to install a fully charged battery
and reprogram the timer.
(Note: A battery alone will not operate the valves in your sprinkling system. The
24-volt transformer must be plugged in and have power to operate your system
normally.)
Set the Time of Day and Date
If this is the first time the timer has been programmed, you should press the small
recessed button labeled reset. Pressing reset does not affect the factory installed
fail-safe program. [See Figure 2]
Figure 2: Programming Keys
To Next Page
Loading...
Need help?
General