10
Enter the Watering Schedule in Any Order
You have the option of entering your watering schedule in whatever order you like.
This feature makes it very easy to review and change your watering schedule. Your
settings can be changed at any time–while you’re setting up the initial schedule, or
after years of operation.
Start Times for Program A or B
A start time is the time of day that the program begins watering the first station,
and all other stations will then follow in sequence. There are not separate start
times for each station. Start times do not correspond to specific stations. If you
enter more than one start time, all stations programmed to operate will water again
(in sequence).
The way you set the start time is the same for both programs. Turn the rotary
dial to the Start Times position in the program that you want to set. The display
will show an A or B depending on which program you have selected. The
display will show – – : – –, and a blinking cursor in Start 1 location
[See Figure 4].
Set the time you want to begin watering for start time 1 using the + or – keys,
then press the enter key. The display will advance to Start 2. For additional
start times, simply repeat this procedure by using the + and – keys to enter the
time, then press enter. Remember, each start time will activate all stations that
are programmed to operate. There are not separate start times for each
station. Start times do not correspond to specific stations.
To Next Page
Loading...
Need help?
General