4
Safety precautions
The precautions described below are intended to ensure the safe and correct use of the product, and to prevent the user and other
personnel from exposure to the risk of injury. Use the product only after carefully reading and fully understanding these instructions.
Handling the product without
observing the instructions
that accompany a "WARNING"
symbol may result in serious
injury or death.
Handling the product without
observing the instructions that
accompany a "CAUTION" symbol
may result in injury or property
damage.
Note
The items under this heading contain important handling instructions that the user should observe to ensure safe use of
the product.
Description of graphic
symbols
Indicates "
PROHIBITED
" actions that
must not be performed.
Indicates "
COMPULSORY
" actions
that must be performed.
Operating environment
Do not use the product in explosive or corrosive environments, in the presence of ammable
gases, locations subjected to splashing water, or near combustibles.
Doing so may result in re, electric shock
or injury.
Handling of this product
Do not transport, install, connect or inspect the product while the power is supplied. Always
turn o the power before carrying out these operations.
This may result in electric shock or
damage to equipment may result.
The terminals on the driver marked
symbol indicate the presence of high voltage.
Do not touch these terminals while the power is supplied.
Doing so may result in re or electric
shock.
Do not use the brake mechanism of the electromagnetic brake motor as a safety brake.
Doing so may result in injury or damage
to equipment.
Only qualied and educated personnel should be allowed to perform installation,
connection, operation and inspection/troubleshooting of the product.
Handling by unqualied and uneducated
personnel may result in re, electric
shock, injury, or damage to equipment.
Use an electromagnetic brake motor in an application of vertical drive such as elevating
equipment.
Failure to do so may result in injury or
damage to equipment.
If the driver protective function is activated, remove the cause before resetting the
protective function.
Installation
The motor and driver are Class I equipment. When installing the motor and driver, ground
their Protective Earth Terminals.
Failure to do so may result in electric
shock.
Connection
Do not machine or modify the connection cable.
This may result in re, electric shock or
damage to equipment.
Do not apply any excessive force to the motor connector.
Do not forcibly bend, pull or pinch the cable.
Do not remove the connector cap until the connection cable is connected so that the O-ring
of the connector connection on the motor is not damaged.
Securely connect and ground in accordance with the connection diagram.
Be sure to observe the specied cable sizes.
Operation
Do not turn the MB-FREE input ON when the electromagnetic brake motor is used in an
application of vertical drive such as elevating equipment. The motor will lose its holding force.
This may result in injury or damage to
equipment.
When the electromagnetic brake motor is used in an application of vertical drive such as
elevating equipment, do not set the “Electromagnetic brake function at alarm” parameter to
“Lock after coasting to a stop.”
Always keep the power supply voltage of the driver within the specied range.
Failure to do so may result in re or
electric shock.
Use a motor, gearhead, and driver only in the specied combination.
Failure to do so may result in re,
electric shock or damage to equipment.
When the electromagnetic brake motor is used in an application of vertical drive such as
elevating equipment, operate it after checking the condition of a load suciently so that a load
in excess of the rated torque is not applied or a small value is not set in the torque limiting value.
Failure to do so may result in injury or
damage to equipment.
To Next Page
Need help?
General
