Maintenance and inspection
−37−
10 Maintenance and inspection
10.1 Inspection
It is recommended that periodic inspections for the items listed below are conducted after each operation of the motor.
If an abnormal condition is noted, discontinue any use and contact your nearest Oriental Motor sales ofce.
Note
•
Do not conduct the insulation resistance measurement or dielectric strength test with the motor
and driver connected. Doing so may cause damage to the product.
•
The driver uses semiconductor elements, so be extremely careful when handling them.
Electrostatic discharge can damage the driver.
During inspection
•
Check if any of the mounting screws of the motor and gearhead are loose.
•
Check if the motor or gearhead generates unusual noises from inside.
•
Check if the output shaft of the motor and gearhead and a load shaft are out of alignment.
•
Check if a damage or stress is applied on the cable or the connection part between the cable and driver is loose.
•
Check if the openings in the driver causes clogging.
•
Check if the mounting screws or the main power supply connection of the driver are loose.
•
Check if the driver generates unusual smells or has foreign objects inside.
10.2 Warranty
Check on the Oriental Motor Website for the product warranty.
10.3 Disposal
Dispose the product correctly in accordance with laws and regulations, or instructions of local governments.
To Next Page
Loading...
Need help?
General
