Y
Programming using the Handset
31
Document Version 2010-07
■ Erasing a number:
1 i {V}/{^}: “Erase” i M i
{V}/{^}: “Yes” i M i {i}
Note:
L When editing, press the desired dial key to add,
^ to erase.
Anonymous calls (Block
Caller ID)
This feature allows the unit to make a call
anonymously.
The default setting is “Off”.
Important:
L We recommend setting with your administrator.
Contact your administrator for further
information.
1 1 (centre of joystick)
2 {V}/{^}: “IP Service” i M
3 {V}/{^}: “Call Features” i M
4 {V}/{^}: “Block Caller ID” i M
5 Proceed with the desired operation.
■ When 1 line is registered:
Go to step 6.
■ When 2 or more lines are registered:
{V}/{^}: Select the desired line. i M
6 {V}/{^}: Select “On” or “Off”. i M i
{i}
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make note of your
new PIN. The unit will not reveal the PIN to you.
If you forget your PIN, contact your phone
system dealer.
1 1 (centre of joystick) i {#}{1}{3}{2}
2 Enter the current 4-digit base unit PIN (default:
“0000”).
3 Enter the new 4-digit base unit PIN. i M
i {i}
Changing the handset name
Each handset can be given a customised name
(“Bob”, “Kitchen”, etc.). This is useful when you
make intercom calls between handsets. You can
also select whether or not the handset name is
displayed in standby mode. The default setting is
“Off”. If you select “On” without entering any
handset name, “Handset 1” to “Handset 6” is
displayed.
1 1 (centre of joystick) i {#}{1}{0}{4}
2 Enter the desired name (10 characters max.;
see the character table, page 48).
L If not required, go to step 3.
3 M
4 {V}/{^}: “On” i M i {i}
Date and time
Set if the unit does not show the date and time. You
can set the date and time through the Web user
interface and also program it to adjust
automatically using the SNTP. Also summer time
setting is available through the Web user interface.
Contact your administrator for further information.
1 1 (centre of joystick) i {#}{1}{0}{1}
2 Enter the current date, month, and year.
Example: 15 March, 2010
{1}{5} {0}{3} {1}{0}
3 Enter the current hour and minute.
Example: 9:30
{0}{9} {3}{0}
L You can select 24-hour or 12-hour clock
format (“AM” or “PM”) by pressing /.
4 M i {i}
Note:
L To correct a digit, push the joystick left, right, up,
or down to move the cursor to the digit, then
make the correction.
To Next Page
Loading...
Need help?
General
