:
Programming using the Base Unit (KX-TGP550 only)
33
Document Version 2010-07
Programmable settings
You can customise the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 33)
– using the direct commands (page 34)
Some of the features can be programmed through the Web user interface (page 40).
L Direct command is the main method used in this User Guide.
Programming by scrolling through the display menus
1
K (middle soft key)
2 Press {^}, {V}, {<}, or {>} to select the desired main menu. i M
3 Press {V} or {^} to select the desired item in sub-menu 1. i M
L In some cases, you may need to select from sub-menu 2. i M
4 Press {V} or {^} to select the desired setting. i M
L This step may vary depending on the feature being programmed.
L To exit the operation, press {b}.
Note:
L See page 34 for the default settings.
L In the following table, ( ) indicates lines you need to select for the settings.
Main menu Sub-menu 1 Sub-menu 2 Page
Line Status
m
––12
IP Service Network Setting DHCP
*1
–
IP Settings
*1
–
Embedded Web 40
Call Features Call Forward
(Line 1: 8 max.)
– Unconditional
*1
– Busy
*1
– No Answer
*1
36
Do Not Disturb
*1
(Line 1: 8 max.)
36
Block Anonymous
*1
(Line 1: 8 max.)
37
Block Caller ID
*1
(Line 1: 8 max.)
38
Ringer Setup
(
Ringer Volume –17
Ringtone (Line 1: 8 max.) –
Interrupt tone ––
To Next Page
Loading...
Need help?
General
