:
Programming using the Base Unit (KX-TGP550 only)
38
Document Version 2010-07
■ Erasing a number:
K i {V}/{^}: “Erase” i M i
{V}/{^}: “Yes” i M i {b}
Note:
L When editing, press the desired dial key to add,
^ to erase.
Anonymous calls (Block
Caller ID)
This feature allows the unit to make a call
anonymously.
The default setting is “Off”.
Important:
L We recommend setting with your administrator.
Contact your administrator for further
information.
1 K (middle soft key)
2 {V}/{^}: “IP Service” i M
3 {V}/{^}: “Call Features” i M
4 {V}/{^}: “Block Caller ID” i M
5 Proceed with the desired operation.
■ When 1 line is registered:
Go to step 6.
■ When 2 or more lines are registered:
{V}/{^}: Select the desired line. i M
6 {V}/{^}: Select “On” or “Off”. i M i
{b}
Date and time
Set if the unit does not show the date and time. You
can set the date and time through the Web user
interface and also program it to adjust
automatically using the SNTP. Also summer time
setting is available through the Web user interface.
Contact your administrator for further information.
1 K (middle soft key) i {#}{1}{0}{1}
2 Enter the current date, month, and year.
Example: 15 March, 2010
{1}{5} {0}{3} {1}{0}
3 Enter the current hour and minute.
Example: 9:30
{0}{9} {3}{0}
L You can select 24-hour or 12-hour clock
format (“AM” or “PM”) by pressing /.
4 M i {b}
Note:
L To correct a digit, press {<}, {>}, {^}, or {V} to
move the cursor to the digit, then make the
correction.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make note of your
new PIN. The unit will not reveal the PIN to you.
If you forget your PIN, contact your phone
system dealer.
1 K (middle soft key) i {#}{1}{3}{2}
2 Enter the current 4-digit base unit PIN (default:
“0000”).
3 Enter the new 4-digit base unit PIN. i M
i {b}
Updating the base unit
software
Your phone system dealer may offer new features
and improve its software version from time to time.
If you set the base unit software update setting to
manual mode through the Web user interface, you
need to download the update when “Update
version.Press OK.” is displayed. Contact your
administrator for further information.
Important:
L Make sure the 4 indicator on the base unit is lit
in green and no line is in use (page 9).
1 Press [ while “Update version.Press
OK.” is displayed.
L The current and new base unit software
versions are displayed.
L If you want to download the update later,
press W. When you are ready to
download, see “Confirming the base unit
software version”, page 39.
To Next Page
Loading...
Need help?
General
