5
1.4. How to Discharge the E. Capacitor on Capacitor P.C.B. Unit
CAUTION:
1. Be sure to discharge the E. Capacitor on CAPACITOR P.C.B. UNIT.
2. Be careful of the high voltage circuit on CAPACITOR P.C.B. UNIT when servicing.
[Discharging Procedure]
1. Refer to the disassemble procedure and remove the necessary parts/unit.
2. Put the insulation tube onto the lead part of Resistor (ERG5SJ102:1kΩ /5W).
(An equivalent type of resistor may be used.)
3. Put the resistor between both terminals of E. Capacitor on CAPACITOR P.C.B. UNIT for approx. 5 seconds.
4. After discharging, confirm that the E. Capacitor voltage is lower than 10V by using a voltmeter.
Fig. F1
To Next Page
Loading...
Need help?
General
