120
English
Schedule playback function using
“Content Management Software”
This unit supports “Content Management Software” to
create schedule data on a PC required to play back still
pictures and motion pictures.
Functions that can be set with “Content Management
Software” are as follows.
•
Content playback (Still pictures/Motion pictures)
•
Music playback
•
Input switch
•
Power control
•
Multi screen display setting of the multi display
•
Caption display
For setting method and details of each function, refer to
the manual of “Content Management Software”.
Note
●
To use this function, set [USB media player] and
[Schedule play function] to [Enable] in [Setup] - [USB
media player settings]. (see page 81)
●
About supported devices, refer to “Supported device”.
(see page 112)
●
When using this function, insert the USB memory
device in power-on state or in schedule standby state.
If the USB memory device is inserted in conditions
other than the said states, the schedule playback is
not performed.
●
Functions restricted when using the “USB media
player” are also restricted when using the schedule
playback function.
■ Schedule play mode
When [USB media player] is set to [Enable] and
[Schedule play function] is set to [Enable], this unit
enters schedule play mode, and the content is played
back according to the set schedule.
If it entered schedule play mode at the time when the
schedule is already specified, the unit operates as
follows according to [Play mode] (see page 82).
•
In [Individual play] mode
Playback starts from the beginning of the specified
schedule.
•
In [Synchronize play] mode
Synchronized playback starts at the next content
start time.
Note
●
When the unit enters schedule play mode, the input is
automatically switched to [USB].
●
Some of the main unit’s functions are disabled during
schedule play mode.
●
If the input is switched during schedule play mode,
the schedule playback is suspended.
To resume the schedule playback
•
Switching the input to [USB] will resume playback
from the next schedule.
•
If the power is turned off using the remote control,
the power is turned on at the next power-on
schedule. Then the schedule playback starts.
The schedule playback is restored by the above
operations.
●
When <RECALL> is pressed during schedule play
mode, the [Schedule play mode] display appears.
●
The scenario playback function of the media player
does not operate in [Schedule play mode].
■ Content playback
Specified content is played back at the time set for
schedule.
Playback files in the following formats are supported.
Still pictures
Extension Format Limitation
jpg/
jpeg/
jpe
JPEG Number of pixels:
Minimum 32 x 18
Maximum 4 096 x 4 096
(supports baseline only)
YUV format:
supports YUV444, YUV442
and YUV440
Colour mode:
supports RGB only
bmp Windows
Bitmap
Number of pixels:
Minimum 32 x 18
Maximum 2 000 x 2 000
(1 bit, 4 bits, 8 bits, 24 bits)
Following formats are not
supported:
Run-length encoding, bit
field, top-down, transparent
data
Motion pictures
Extension
Codec
Video Audio
avi H.264/MPEG4
AVC
MPEG4 Visual
VC-1 Advanced
VC-1 Simple &
Main
AAC-LC/LPCM/MP3
WMA Standard
wmv H.264/MPEG4
AVC
MPEG4 Visual
VC-1 Advanced
VC-1 Simple &
Main
LPCM/MP3/
WMA Standard/WMA9/
WMA10 Pro
mp4 /
mov
H.264/MPEG4
AVC
MPEG4 Visual
H.265/HEVC
AAC-LC/HE-AAC/MP3
To Next Page
Loading...
Need help?
General