65
English
Failover/Failback
Automatically switches to the backup input if an
interruption of video occurs.
Note
●
MEMORY VIEWER / Screen Transfer input is
excluded from this function.
1. Setting the input change mode
■ [Input change mode]
[Off]:
Disables the Backup Input function.
Failover/Failback
Input change mode Off
[Quick]:
Promptly switches to the backup input if an
interruption of video occurs.
The backup video signal needs to be in the same
format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the (main) input used
for viewing will be inherited.
Failover/Failback
Input change mode
Primary backup input
Auto switch back mode
Backup input change
Secondary backup input
Main input
Current input
Quick
HDMI1
HDMI2
Disable
Active
HDMI2
Main input
Changing mode High speed
[Normal]:
Switches to the backup input if an interruption of
video occurs.
The backup video signal does not need to be in the
same format as the (main) input in use for viewing.
Upon switching to the backup input, the video and
audio adjustment values for the backup input will
be used.
1-1 [Input change mode]: [Quick] detailed
settings
Promptly switches to the backup input if an
interruption of video occurs, and enables switching
between digital (HDMI1 / HDMI2) inputs.
Note
●
This function will start operating once a video signal is
detected by both the input in use for viewing and the
backup input and the [Backup input change] item is
displayed as [Active].
●
This function may not operate correctly depending on
the image playback device or video signal.
■ [Primary backup input]
Sets the first priority backup input.
(None) / [HDMI1] / [HDMI2] / DisplayPort] / [DVI-D]
/ [SLOT]
The input that is of the same type as the one in use
for viewing will be greyed out.
■ [Secondary backup input]
Sets the second priority backup input.
(None) / [HDMI1] / [HDMI2] / DisplayPort] / [DVI-D]
/ [SLOT]
The input that is of the same type as the one in use
for viewing will be greyed out.
■ [Auto switch back mode]
Sets whether or not to automatically return to the
former (main) input when the former input video
initially viewed is restored while viewing the video
of the backup input enabled by the operation of the
Backup Input function.
[Disable]:
Unreturned
[Enable]:
Returned
■ [Changing mode]
Select speed of input switching.
[High speed]:
If switching between the same signal formats, it is
possible to switch within 1 second.
If switching between the different signal formats,
picture noise is caused.
[Normal speed]:
If switching between the same signal formats, it is
possible to switch within 2 seconds.
If switching between the different signal formats, it
takes 3 to 4 seconds to switch but picture noise is
not caused.
To Next Page
Loading...
Need help?
General