UNPACKING AND PARTS IDENTIFICATION
Consider the following when unpacking the printer:
•
The box should stay right-side up.
•
Lift the printer out of the box carefully.
•
Remove the plastic covering from the printer.
•
Remove the accessory items from their protective containers.
•
If the printer has been stored in a cold environment, allow it to reach
room temperature before powering it on.
•
Set the printer on a solid, flat surface. Inspect the shipping container
and printer for any signs of damage that may have occurred during
shipping.
NOTE: The following illustrations are representative only. Your printer may not be
packed exactly as shown here, but the unpacking steps are similar.
8
Section 2. Installation
PTR3E Packing
To Next Page
Loading...
Need help?
General
