Verify that you have the following materials when unpacking:
•
Printer
•
Power Cord
•
Extra Ribbon Core
•
Operator and Technical Reference Manual
SETTING UP THE PRINTER
Consider the following when setting up the printer:
•
Locate a solid flat surface with adequate room to set the printer. Make
sure there is enough room at the top and right-hand (facing the printer)
side to provide clearance for the label access door to swing open.
•
The location should be near the host computer or terminal. The maximum
distance for RS232 cables is 35 feet and six feet for IEEE1284 Parallel
cables. Cables can be purchased locally, and their configuration will
depend upon the host system being used. An IEEE1284 compliant cable
must be used to realize the full throughput potential of the printer.
9
Section 2. Installation
Printer
Power Cord
Operator Manual
Extra Ribbon Core
To Next Page
Loading...
Need help?
General
