9.3 Wi-Fi WAN
To access Wi-Fi WAN settings, click Network>WAN>Details .
Enter a name to represent this WAN connection.
Independent from
Backup WANs
If this is checked, the connection will be working independent from other Backup
WAN connections. Those in Backup Priority will ignore the status of this WAN
connection, and will be used when none of the other higher priority connections
are available.
This setting specifies the state of the WAN connection while in standby. The
available options are Remain Connected (hot standby) and Disconnect (cold
standby).
This setting specifies the maximum transmission unit. By default, MTU is set to
Custom 1440 . You may adjust the MTU value by editing the text field. Click
Default to restore the default MTU value. Select Auto and the appropriate MTU
value will be automatically detected. The auto-detection will run each time the
WAN connection establishes
If this setting is disabled, the WAN connection will not respond to ICMP ping
requests. By default, this setting is enabled.
To Next Page
Loading...
Need help?
General
