19 NAT Mappings
NAT mappings allow IP address mapping of all inbound and outbound NAT’d traffic to and from
an internal client IP address. Settings to configure NAT mappings are located at Advanced >
NAT Mappings .
To add a rule for NAT mappings, click Add NAT Rule .
NAT mapping rules can be defined for a single LAN IP Address , an IP Range ,
or an IP Network .
This refers to the LAN host’s private IP address. The system maps this address
to a number of public IP addresses (specified below) in order to facilitate
inbound and outbound traffic. This option is only available when IP Address is
selected.
The IP range is a contiguous group of private IP addresses used by the LAN
host. The system maps these addresses to a number of public IP addresses
(specified below) to facilitate outbound traffic. This option is only available when
IP Range is selected.
The IP network refers to all private IP addresses and ranges managed by the
LAN host. The system maps these addresses to a number of public IP
addresses (specified below) to facilitate outbound traffic. This option is only
To Next Page
Loading...
Need help?
General
