If the check is carried out after the vehicle has
been used, and therefore with a hot engine, the
level will be lower; in order to carry out a correct
check, wait at least 10 minutes after the engine
has been stopped so as to get the correct level.
Engine oil top-up
The oil should be topped up after having checked
the level and in any case by adding oil without
ever exceeding the MAX. level.
Restoring the level from the MIN to the MAX marks
requires approx. 400 m³ of oil.
Engine oil filter
Change oil and replace filter as indicated in the scheduled maintenance table. Use new oil of the rec-
ommended type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and the oil drainage plug, screwing them up to the specified torque. Refit the new cartridge
filter being careful to lubricate the O-ring before fitting it. Change the engine oil.
Recommended products
eni i-Ride PG 5W-40 Synthetic based lubricant for high-performance four-stroke engines.
JASO MA, MA2 - API SL - ACEA A3
Oil pressure warning light
The vehicle is equipped with a telltale light on the
dashboard that lights up when the key is turned to
the «ON» position. However, this light should
switch off once the engine has started.
If the light turns on during braking, at idling
speed or while turning a corner, it is necessary
to check the oil level and the lubrication sys-
tem.
MSS X10 500ie Executive Maintenance
MAIN - 33
To Next Page
Loading...
Need help?
General