Running in
Distance covered Speed limit to be not exceeded during the period of running
in (Km/h) – (Mls/h)
1
st
Gear 2
nd
Gear 3
rd
Gear 4
th
Gear
First 2000 Km. Kms Mls Kms Mls Kms Mls Kms Mls
(1250mls) 25 15.5 38 23.5 52 32 70 43
Notice - After first 1000 Km. (620 mls):
- Check that all nuts and bolts are not loose: in particular the nut for securing wheels.
- Check that the carburettor is tight on the crankcase to avoid any possibility of air leaks.
- Clean air filter and control tire pressures.
- Check spark plug.
After first 1000 Km. (620 mls)
change oil in the gear box (see fig. 11 and page 52).
LIGHTING AND SIGNALLING DEVICES
The vehicle is equipped with:
- Main switch « C on handlebars, R. H. side, with lever « D » high and low beam and 2
push buttons « E » for the horn and « M , for engine cutout (refer to fig. 6).
ELECTRICAL EQUIPMENT
A six pole flywheel magneto - nominal voltage 6 V - supplies alternating current to the
electrical equipment (refer to diagram fig. 7).
This equipment consists of the following lighting and signalling devices:
Front headlamp, circular shaped 0 130, with 6V-25/25W bilux bulb (High and low beam),
6V-5W bulb for front parking light and two 6V0.6W bulb for speedometer and for High and
low beam indicator light.
Tail lamp, with 5 W bulb (red parking light and license plate illumination) and 10 W bulb
(red stop light).
Light switch on the headlamp, located on handlebars, R. H. (see fig. 6).
STARTING
Carry out the operations indicated onfig. 8.
As soon as the engine is running smoothly bring the starter control back to its
normal position.
Notice - When it is necessary to decelerate do not hesitate in changing down.
To Next Page
Loading...
Need help?
General