Maintenance
ADJUSTMENT ON CARBURETTOR
For adjusting the idling act on the slow running adjuster screw (fig. 9 No. 5) coming out on
air cleaner.
On the carburettor body a set screw is applied for adjusting the throttle cable play; this
screw is to be reset only if necessary or on dismantling and reassembly operations.
On the carburettor there is a spring loaded screw for adjusting the idling (fig. 9, No. 14).
For not influencing the engine running at idle speed, unless otherwise unavoidable,
customers should avoid re-setting this screw. Any alteration should preferably be
entrusted to a Service Station.
Notice Avoid re-setting of the screw for adjusting the idling (Fig. 9, No. 14). Consult a
Service Station.
STARTING UP
(when the engine is flooded)
In the case of difficulties caused by flooding (presence of unvaporized mixture in the
cylinder) , the following methods can be used:
- Attempt push starting: mesh the 2nd gear, declutch, push the vehicle to a certain speed,
sharply release the clutch and when the engine fires declutch.
- Close the fuel cock (« A » fig. 8) remove the sparking plug (refer to instruction at page
17) and clean; then kick over the engine several times.
- Screw in the sparking plug by hand and lock it securely with the box wrench, open the
fuel cock and kick over the engine.
Notice - When reassembling- the spark plug ensure that it is introduced into the threaded
hole at the correct inclination; use the wrench only for tighten.
To Next Page
Loading...
Need help?
General