EN 14
• If there is a temporary lack of voltage or after switch-off, the manual
functioning will be maintained as well as the previously set output
percentage value.
• If the sensor breaks during automatic functioning, the controller
moves to manual mode while maintaining the output percentage
command unchanged as generated by the P.I.D. immediately before
breakage.
7.7 Memory Card (optional)
Parameters and setpoint values can be duplicated from one controller to
another using the Memory card.
There are two methods:
• With the controller connected to the power supply.
Insert memory card when the controller is off.
On activation display 1 shows
and display 2 shows
(only if the correct values are saved in the memory card).
By pressing the
key display 2 shows , then confi rm using
the
key. The controller loads the new data and starts again.
To Next Page
Loading...
Need help?
General