15 EN
• With the controller not connected to power supply.
The memory card is equipped with an internal battery with an
autonomy of about 1000 uses (2032 button battery, replaceable).
Insert the memory card and press the programming buttons.
When writing the parameters, the led turns red and on completing the
procedure it changes to green. It is possible to repeat the procedure
without any particular attention.
1
If on activation the controller does not display it means no data have been
saved on the memory card, but it is possible to update values.
7.8 Loading default values
Press Display Do
1
SET
for 3 second
Display 1 shows
with the 1
st
digit
fl ashing, while display 2
shows
.
2
or
Change the fl ashing
digit and move to the
next one using the
key.
Enter password:
.
3
SET
to confi rm
Display 1 shows the
fi rst parameter and
display 2 shows the
value.
Updating Memory Card
To update the memory card values, follow the
procedure described in the fi rst method, setting
display 2 to
so as not to load the parameters
on controller
1
.
Enter confi guration and change at least one
parameter.
Exit confi guration. Changes are saved automatically.
WARNING
To Next Page
Loading...
Need help?
General