99
MAINTENANCE
Emission Control Information
Any qualified repair shop or qualified person may maintain, replace, or
repair the emission control devices or systems on your snowmobile.
Emission Control Label
Your snowmobile is equipped at the time of sale with an emission con-
trol information (ECI) label and a factory-installed emissions informa-
tion hangtag. These items are required by U.S. Environmental
Protection Agency regulations. The ECI label is permanently affixed to
either the right side of the tunnel or the engine recoil cover. The ECI
label should not be removed, even after you purchase the snowmobile.
You may remove the factory-installed emissions information hangtag,
which is intended solely for your use in making a purchasing decision.
Emission Control Maintenance Requirements
Your snowmobile is certified to operate on gasoline with a minimum
octane level of 87 (R+M)/2. The emission control system designation
per SAE J1930 is MFI. If your snowmobile is equipped with a check
engine light and it comes on, you must take your snowmobile to a quali-
fied dealer for diagnostic service. Specifications and adjustments for
engine tune-ups are located in the Service Manual, which is available to
your qualified service technician. Reverse (if equipped) must not be
engaged during engine tune-ups.
To Next Page
Loading...
Need help?
General
