52
FEATURES
Instrumentation
MFD Digital Display Programs
M-10 ACE Suspension Adjustments (Cruiser)
A switch on the console
(above the ignition switch)
allows you to adjust the
M-10 ACE suspension
with the MFD control
switch. See page 71 for
instructions.
MFD Battery Replacement
Models equipped with the clock feature
have a battery to power the clock. If the
clock function of the MFD isn't working
properly, replace the battery. Replace-
ment batteries are available from your
dealer.
1. Remove the plenum from the under-
side of the hood.
2. Locate the black battery compart-
ment. It has a red wire and a brown
wire with a white stripe. It's located
about three inches down the main
harness from the point where the
harness connects to the MFD.
3. Cut the plastic cable tie from the
outside of the compartment.
4. Carefully cut the bottom of the compartment (opposite the wires) to
separate the heat-sealed seams. Squeeze the corners of the compart-
ment inward so the battery is visible.
NOTE: Note the orientation of the battery before removing it. An incorrectly
installed battery will not maintain the clock.
GAUGE
ACE
ACE Suspension
Adjustment Switch
To Next Page
Loading...
Need help?
General
