EasyManuals Logo
Home>Polaris>Snowmobiles>FST IQ Cruiser

Polaris FST IQ Cruiser User Manual

Polaris FST IQ Cruiser
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
87
OPERATION
Starting the Engine
1. Turn the key to the ON position.
2. Pull the engine stop switch up to the RUN position.
3. Do not apply throttle when starting the engine unless extremely cold
temperatures (below -15° F/-26° C) prevent the engine from start-
ing.
NOTE: Under these conditions, attempt to start the engine without using the
throttle. If two to three attempts are unsuccessful, apply 1/8 to 1/4
throttle while cranking the engine. Ease off the throttle immediately
when the engine starts. Continue to apply just enough throttle to keep
the engine running until it idles smoothly.
4. Turn the key to START to crank the engine. Release the key to the
ON position when the engine starts.
5. Repeat the cranking procedure as needed until the engine starts.
NOTE: Always allow the engine to warm up to full operating temperature
(150° F/65° C) before shutting it down. Avoid starting and stopping the
engine with less than 5 minutes of run time when the engine is cold.
WARNING
Before starting the engine, always refer to all safety warnings pertaining to
snowmobile operation. Never start your snowmobile without checking all
components to be sure of proper operation. See Check Before Starting the
Engine beginning on page 77.
CAUTION
To avoid injury and/or engine damage, do not operate the electric starter
while the engine is running.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris FST IQ Cruiser and is the answer not in the manual?

Polaris FST IQ Cruiser Specifications

General IconGeneral
BrandPolaris
ModelFST IQ Cruiser
CategorySnowmobiles
LanguageEnglish

Related product manuals